Technical data

Outgoing Call Access 1-172
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Enable CO Dial Tone Detect
Use PGM 160, then FLEX 6 … see page 1-30.
OPERATION / SETUP
To store a number in a System Speed Dial from the System Attendant:
To store Station Speed Dial numbers from a digital phone:
1. Press [TRANS/PGM], then press [SPEED].
2. Enter the System Speed Dial bin to be dialed (see Additional Information in (see
CONDITIONS).
3. Press the CO Line or Group button, if applicable.
4. Dial the appropriate telephone number, and include any of the following as needed:
• [CALLBK] = inserts a pause.
• button = if stored as the first digit, its function is Display Security. Otherwise, its
function is to change to Pulse (for DTMF Switchover).
• [DND/FWD] = for Dial Tone Detect or Pause (see CONDITIONS).
• [FLASH] = inserts a Flash into the speed number (see CONDITIONS).
5. Press [HOLD/SAVE] to complete the entry.
Hint: At this point, the "Character Entry Chart" on page D-50 can be used to enter a
name (max. 12 characters) as needed.
6. Press [HOLD/SAVE] to store the setting (including the name if used), and complete
the dialing sequence.
To store continuously, repeat this procedure from Step 3.
To make a call using System Speed Dial from a digital phone:
1. Go off-hook.
2. Press [SPEED], then enter the Station Speed Dial bin (2000-2499).
Toll Check -- if value is set to ON, the speed dial of this
zone is checked by the toll table.
PGM 232 + FLEX 3 + 0
(Value) +
[HOLD/SAVE]
VALUES --
0 =Off
1 = On
Authorization Check -- if value is set to ON, the station
user must enter the authorization code to use the
speed dial of each system speed zone.
PGM 232 + FLEX 4 + 0
(Value) +
[HOLD/SAVE]
VALUES --
0 =Off
1 = On
Release 3.5
June 2010