Technical data

Outgoing Call Access 1-171
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
• Additional information:
ADMIN PROGRAMMING
Enable Speed Dial Access
Set System Speed Zone
Enter the appropriate Speed Zone number (Range = 01-10) and select specific procedure:
SYSTEM SPEED DIAL
SPEED DIAL RANGE DESCRIPTION
2000-2199 Unrestricted
2200-2499 Restricted by Station COS
SYSTEM COS
COS 1 Unrestricted
COS 2 Monitored by Exception Table A
COS 3 Monitored by Exception Table B
COS 4 Monitored by Exception Table A & B
COS 5 Long distance calls are not allowed; the dialed
digits can be longer than 7 digits.
COS 6 Long distance calls are not allowed; only a
max of 7 digits may be dialed.
COS 7 Only intercom, paging, and emergency calls
are allowed; no dialing allowed on CO Lines.
Speed Dial Access -- if value is set to ON, the station user can
use system speed dial to place a call.
PGM 112 + FLEX 9 + 1
(Enable) + [HOLD/SAVE]
VALUES --
0 = Disable
1 = Enable
Speed Bin Range in Zone -- a system speed zone can
be grouped up to 10 system speed zones. The system
speed bin section between 2000 and 2199 is defined
as the toll free zone; the System speed dial numbers
within this zone are not checked by the toll table.
PGM 232 + FLEX 1 +
Value (sys speed zone)
+ [HOLD/SAVE]
VALUES --
Speed Bin Range for
Zone = 2200-2499
Station Range to Access Zone -- the accessibility of
system speed zones can be assigned to each station.
NOTE: When there are too many Stations to see, you
can scroll data using the volume up/down keys.
PGM 232 + FLEX 2 +
Station Range (Range
= 100-131) +
[HOLD/SAVE]
If a range is not
entered & saved, use
the BACK softkey to
access FLEX 3-4.
Release 3.5
June 2010