Technical data

General Information 1-4
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
By default, there is no password.
4. Each program is accessed by pressing the [TRANS/PGM] button The following will
initially display:
5. Dial the desired three-digit program number. If an error is made while entering data,
the [TRANS/PGM] button will return to the previous status.
NOTE: To return to the previous state while in Admin Programming, press the [BACK] soft
button to clear the temporary data fields.
Entering Ranges for Stations, COs, & Groups
The following Table is frequently used in Admin Programming procedures. When entering each
range, refer to the table, as the range is not always mentioned in the procedures. When entering
a programming area that involves stations or CO lines, you are prompted to enter the range of
stations or CO lines that you want to modify. To modify a single station or CO line, enter the
same number twice, e.g., 100100 = Sta 100 only, 01-01 CO line 1 only.
Saving System Changes
To accept changes while programming:
1. Press the [HOLD/SAVE] button when all changes have been entered to store the data
permanently.
2. A confirmation tone sounds when pressing the [HOLD/SAVE] button, if all data was
entered correctly. If there were any errors in the entering of data, an error tone will be
presented and data will not be stored in the permanent memory.
Resetting the System
To reset the System:
Enter [PGM] + 450 then [FLEX] + 15 and press the [HOLD/SAVE] button.
ADMIN PROGRAM START
BACK DELETE SAVE
ENTER PGM NUMBER
BACK DELETE SAVE
STATION RANGE CO RANGE CO LINE GROUP RANGE
100-131 01-12 01-24
Release 3.5
June 2010