Technical data

Outgoing Call Access 1-165
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
• To use this feature on a digital phone, the phone must have a labeled [REDIAL] button or
a programmed {Redial} flex key.
• To use this feature on analog CO Lines, Call Progress Tone Detection Units (CPTU) must
be applied.
• When a predefined CO Line is busy in ACNR mode, an available CO Line within the same
group is used.
ADMIN PROGRAMMING
Set ACNR Pause Timer
Set ACNR Delay Timer
Enable ACNR Tone Detect Timer (analog CO lines only)
Set ACNR No Answer Timer
Set ACNR Retry Counter
Set ACNR Tone Cadence
Use PGM 423 … see page 1-243.
ACNR Pause Timer -- when the ANCR Pause Timer
expires, ACNR is activated.
PGM 180 + FLEX 10 +
030 Seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 005-300
ACNR Delay Timer -- designates the time delay when
there is no available CO Line in the group.
PGM 180 + FLEX 8 +
030 Seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 000-300
ACNR No Tone Detect Timer -- when a call to a busy
station is made, the CPTU attempts to detect the valid
tone type until ACNR Tone Detect Timer expires.
PGM 180 + FLEX 13 +
030 Seconds (3 digits)
+ [HOLD/SAVE]
VALUES --
Range = 001-300
ACNR No Answer Timer -- the system detects a CO ring
back tone the CO. If the call is not answered, the system
will disconnect the call.
PGM 180 + FLEX 9 +
30 Seconds (2 digits) +
[HOLD/SAVE]
VALUES --
Range = 00-50
ACNR Retry Timer -- ACNR is executed up to this value.
After the timer expires, ACNR is canceled.
PGM 180 + FLEX 11 +
03 Value (2 digits) +
[HOLD/SAVE]
VALUES --
Range = 01-30
Release 3.5
June 2010