Technical data

Outgoing Call Access 1-160
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Access Leading Digit Table
• A maximum of 250 LDT entries can be programmed. Each LDT entry has six
sub-attributes: LCR type, LCR code, DMT index for Day Zone 1/2/3, and Check
Password.
• DMT Index -- Meaning of 6 digits: each pair (2 digits) is the index to the DMT for the
each time Zone 1/2/3. (The [SPEED] button is used to validate the remaining index).
• Enter the appropriate VALUE (LDT Table, Range = 000-249) and follow the specific
procedure as listed in the Table.
LCR Type -- used to select the LCR Type. PGM 221 + FLEX 1 + 3
Value (LCR Type) +
[HOLD/SAVE]
DEFAULT = Both
VALUES --
1 = INT (checks entry
only for internal dialing)
2 = COL (checks entry
only after dialing CO
Access Code)
3 = BOTH (checks entry
for both INT and COL)
LCR Code -- if digits dialed by the user are equal
to determined value, the digits will be converted
and a CO line will be secured according to DMT.
PGM 221 + FLEX 2 +
Value (2 digits; 0-9, #,
*) + [HOLD/SAVE]
VALUES --
max. 12 digits
DMT Index for DAY Zone 1 -- used to set the table
index DMT of Day Zone 1. Because Day Zone 1
has three different time zones, all three table
indices of each time must be selected.
PGM 221 + FLEX 3 +
Value (DMT Index, 6
digits) + [HOLD/SAVE]
VALUES --
Range = 00-99
DMT Index for DAY Zone 2 -- used to set the table
index DMT of Day Zone 2. Because Day Zone 2
has three different time zones, all three table
indices of each time must be selected.
PGM 221 + FLEX 4 +
VALUE (DMT Index, 6
digits) + [HOLD/SAVE]
VALUES --
Range = 00-99
DMT Index for DAY Zone 3 -- used to set the table
index DMT (PGM 222) of Day Zone 3. Because
Day Zone 3 has three different time zones, all
table indices of each time must be selected.
PGM 221 + FLEX 5 +
Value (DMT Index, 6
digits) + [HOLD/SAVE]
VALUES --
Range = 00-99
Check Password -- if value is set to ON, the SBX
IP system will request the User account code
when dialed digits match the LCR code.
PGM 221 + FLEX 6 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off (default)
1 = On
Release 3.5
June 2010