Technical data

Outgoing Call Access 1-155
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
CONDITIONS
• A Hot Line or Warm Line destination can be either a CO Line or CO Line Group. This
function can be setup on a flex button or at another station.
• If a user dials another number prior to the Warm Line Timer expiration, the call will be
processed as a normal call, not as a Warm Line call.
• If there is no flex button at a station, the number is processed as a Speed Dial Number.
• The set value of the Warm Line Timer must be less than that of the Dial Tone Timer.
• A flex button may be assigned as an Idle Line Selection button.
• When lifting the handset or pressing the [SPEAKER], the system behaves as it would if a
predefined button was pressed.
• It is possible to activate the Hot Line/Warm Line feature for an SLT station.
ADMIN PROGRAMMING
Set Warm Line Timer
Enable Warm Line
Set Idle Line Selection
Warm Line Timer -- designates the amount of time before
a warm line state exists on an idle line after lifting handset
or pressing the [SPEAKER] button.
PGM 182 + FLEX 8 + 05
Seconds (2 digits) +
[HOLD/SAVE]
VALUES --
Range = 01-20
Warm Line -- if value is set to HOT, the station user can use
Hot Line. Otherwise, in the Warm Line state, the Warm Line
Timer will start when the user lifts the handset or presses the
[SPEAKER] button.
PGM 113 + FLEX 7 + 0
(Warm) + [HOLD/SAVE]
VALUES --
0 = Warm
1 = Hot
PGM 122
Idle Line -- designates Hot Line or Warm
Line.
PGM 122 + 1 (ITEM, refer to Table) + RANGE
(1-4 digits, refer to table) + [HOLD/SAVE]
VALUES --
see table
ITEM RANGE FUNCTION
1 - Flex 01-44 To activate a feature on a flexible button.
2 - CO Line 01-12 To secure a CO Line.
3 - CO Line Group 01-24 To secure a CO Line Group.
4 - Station 100-131 To call another station
Release 3.5
June 2010