Technical data

General Information 1-2
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
About This Guide
This manual is designed to provide information regarding SBX IP 320 general system feature
operation. In most cases, each feature described will contain three sections in the following
order:
• CONDITIONS: explains any requirements or constraints of the feature related to its
configuration.
• ADMIN PROGRAMMING: provides information about configuring the feature using a
digital phone.
• OPERATION / SETUP: describes how to use and/or set up the feature using a digital
phone.
Programming Guidelines
The SBX IP System can be programmed to meet each customer's individual needs. The
elements of Basic Admin Pre-programming are covered in the SBX IP Installation Guide, and
can help to ensure you are prepared for Admin Programming of your SBX IP System.
Pre-Programming (Installation)
Pre-programming for the following should have been done immediately following Installation of
the SBX IP System. For details, refer to Chapter 6 "Starting the SBX IP" in the SBX IP
Installation Guide.
PC Admin Programming
You must
use the PC Admin application to set the following IP parameters which are located in
the VoIP appendix:
PGM 386 - IP Phone Attributes (MAC address) … see page B-13
PGM 500 - SIP Attributes I … see page B-15
PGM 501 - SIP Attributes II … see page B-16
Feature PGM Code Install Guide (page #)
Default System (Reset) 450
6-5
If you have the 3.0
Install Guide "open",
you can use the blue
hyperlinks to "jump"
to these locations ...
Site Name 100
6-6
Board Assignment 101
6-8
Numbering Plan Type
104
6-10
System IP Settings
108
6-14
Release 3.5
June 2010