Technical data

ISDN Service 1-145
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
ADMIN PROGRAMMING
Enable CLI Transit Option
Enable CO Account feature
Use PGM 141, then Btn 9 … see page 1-21.
Enable Forced Station Account feature
Use PGM 112, then Btn 20 … see page 1-22.
Enable LCR Password feature
Use PGM 221, then Btn 6 … see page 1-157.
Calling Party Number (CPN) Service
In the case where the Calling Party Number (CPN) information for an ISDN incoming call has
two elements, the SBX IP 320 provides an option that allows either of these elements to be
displayed. Usually one element is the actual CPN, while the other element may be the transit
CPN of the network.
CONDITIONS
• If the CPN value is set to 1, the Real CPN is displayed.
• If the CPN value is set to 0, the Transit Point CPN is displayed.
ADMIN PROGRAMMING
Select CPN Value
CLI Transit -- if value is set to ORI, the caller’s
CLI will be sent for CLI; otherwise, the call
forwarding station’s CLI is sent.
PGM 143 + FLEX 7 + 0
(CFW) + [HOLD/SAVE]
VALUES --
0 = CFW, send CLI as call
forwarding station's CLI
1 = ORI, send CLI as
original caller's CLI
Double CLI Service (Calling Party Number Service) -- if value
is 1, the real CPN is displayed. If this value is 0, Transit Point
CPN is displayed.
PGM 143 + FLEX 15 + 1
(ORI) + [HOLD/SAVE]
VALUES --
0 = Transit
1 = ORI
Release 3.5
June 2010