Technical data

ISDN Service 1-140
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
• If a value is entered for the My Area Prefix Code, it can be used in conjunction with the
"MY AREA CODE" feature.
• When a value is entered in the CLIP/COLP Table, and the CLIP Table Index is set as the
front entry number, it is used as the middle portion of CLI when the outgoing CLI is
generated.
• If the CLI Restriction is enabled, CLI transmission is restricted.
• Any stored CLI messages are not erased if the system is powered down for any reason
(such as a power outage).
ADMIN PROGRAMMING
Access CLIP/COLP Table
Access CLIP/COLP Table Index
Set Call Type
Enable ISDN CLI of STATION
COLP Table -- the COLP table is used for
outgoing CLI.
PGM 201 + COLP Table Bin Number
(Range = 00-49) + Value 2 (up to 10
digits) + [HOLD/SAVE]
VALUES --
PGM 143 -
FLEX 1 and 2
COLP Table Index -- if value is set to 50, the CLI of this CO
Line refers to PGM 114 - FLEX 5. If this value is set to 00-49,
the CLI of this CO Line refers to the COLP Table (PGM 201).
PGM 143 + FLEX 1 +
Value (00) +
[HOLD/SAVE]
VALUES --
Range = 00-50
CLIP Table Index -- if value is set to 50, the CLI of this CO Line
refers to PGM 114 - FLEX 5. If this value is set to 00-49, the
CLI of this CO Line refers to the COLP Table (PGM 201).
PGM 143 + FLEX 2 +
Value (00) +
[HOLD/SAVE]
VALUES --
Range = 00-50
Call Type -- used to set the call type of ISDN CO line CLI. PGM 143 + FLEX 3
+ 2 (National) +
[HOLD/SAVE]
VALUES --
0 = Unknown
1 = International
2 = National
3 = Not used
4 = Subscriber
ISDN CLI STA -- used as outgoing CLI when
outgoing CLI is active and CLI type is EXT (station).
PGM 114 + FLEX 12 +
Value + [HOLD/SAVE]
VALUES --
Default = Logical Sta No.
Release 3.5
June 2010