Technical data

ISDN Service 1-139
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Enable CLI Message Wait
Set My Area Code
Set My Area Prefix Code
Outgoing CLI Service
When enabled, this feature sends calling information to any destination an SBX station dials.
NOTE: Whether or not the information is then displayed on the destination phone depends upon whether
or not that phone has incoming CLI capability.
CONDITIONS
• When the Call Type is set to NATIONAL, the outgoing CLI is generated as a National
Number.
• When a value is entered for the ISDN CLI of a station, the value entered is used as the CLI
suffix when the outgoing CLI is generated.
• When a value is entered in the MY AREA CODE field, the entered value is used as the
CLI prefix when the outgoing CLI is generate.
CLI MSG Wait -- if value is set to ON, the station can receive CLI
messages from an incoming CO call, when the station doesn't
answer.
PGM 114 + FLEX 4 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
My Area Code -- this value is used to set your area code.
The combination of this value and PGM 200 - FLEX 10 is
compared with the received CLI, and the received CO call can
be judged the local call or the long distance call.
This value is also used for outgoing CLI data, when a station
makes an outgoing CO call.
PGM 200 + FLEX 9 +
Value + [HOLD/SAVE]
VALUES ---
max. 6 digits
My Area Prefix Code -- this value is used to set your area prefix
code. (Normally zero value)
The combination of this value and PGM 200 - FLEX 9 is
compared with the received CLI, and the received CO call can
be judged the local call or the long distance call.
This value is also used for outgoing CLI data, when a station
makes an outgoing CO call.
PGM 200 + FLEX 10 +
Value + [HOLD/SAVE]
VALUES --
max. 4 digits
Release 3.5
June 2010