Technical data

Incoming Call Pickup 1-130
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
Apply ICLID Features
Access the DID Conv Table
Use PGM 231 … see page 1-119.
Initialize the ICLID Table
DID/DISA Call Routing for Station in DND or Pre-selected Message
Mode
A DID/DISA call can be routed (forwarded) to a specific destination when a called station is in
DND or in Pre-selected message mode.
There are three destinations available for re-routing the call:
• Tone - caller will hear a busy tone.
• Attendant - caller will be routed to the attendant
• Hunt Group - call will be routed to a designated hunt group
CONDITIONS
• The flow is the same for DID/DISA as the other destinations set for DID call routing (see
1-123).
• If [P-MSG DND] Admin is enabled, rerouted flow is the same as Busy. However, if [P-MSG
DND] Admin is disabled, the route operation doesn't work even though the station is
Pre-Selected MSG state.
• If calls routed to a hunt group, hunt group rules will be applied - see 1-96.
ADMIN PROGRAMMING
Reroute Calls for Tone
Use PGM 167, FLEX 4, then FLEX 1 … see page 1-124.
ICLID Table Usage -- if value is set to ON, ICLID service is
available. An incoming call is routed to the programmed
destination by CLI information. Destination can be
programmed in PGM 237 (Incoming CLI Destination Table)
PGM 143 + FLEX 18 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Tables Initialization -- LCR TABLE
INITIALIZATION (PGM 223)
By using PGM 223, the tables
which are related to LCR feature
can be initialized.
PGM 450 + FLEX 11 Also used for: PGM 227 - 229 and
PGM 232 - 237
Release 3.5
June 2010