Technical data

Hunt Groups 1-102
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
CIRCULAR/TERMINAL GROUP ATTRIBUTES
VMIB Announce 2 Repeat Enable/Disable -- used to
enable or disable the VMIB Announce 2 Repeat.
PGM 191 + FLEX 6 + 1
(On) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Overflow Destination -- calls to a station in the group
will continue to route until answered or each station in
the group has been tried. The call will remain at the
last station in the group or will be passed to the
overflow station/group/ VMIB/System Speed bin, after
the overflow timer expires.
PGM 191 + FLEX 7 +
Value (Destination Type
1-4) + Value (Sta/Hunt
Group/VMIB/Speed Bin)
+ [HOLD/SAVE]
VALUES --
1 = Station #
2 = Hunt #
3 = VMIB 00-70
(00 = not assigned)
4 = System Speed
# (2000-2499)
Overflow Timer -- if timer expires after a call is
received in the group, the call will be routed to the
overflow destination.
PGM 191 + FLEX 8 + 180
seconds + [HOLD/SAVE]
VALUES --
Range = 000-600
Wrap-up Timer -- is used to delay new calls to a
member of the Hunt Group that has just become idle.
PGM 191 + FLEX 9 + 002
seconds + [HOLD/SAVE]
VALUES --
Range = 000-999
No Answer Timer -- in circular/terminal Hunt Group, if
the incoming call is not answered during the allowed
time, the call will be routed to the next idle station in
the group.
PGM 191 + FLEX 10 + 15
Seconds (Value) +
[HOLD/SAVE]
VALUES --
Range = 00-99
Pilot Hunt -- if value is set to ON, calls to the each
Hunt Group member will be processed as a call to
Hunt Group. A circular/terminal hunt group can be
assigned with a pilot number so that only calls to the
pilot number will be treated as calls to the Hunt Group.
PGM 191 + FLEX 11 + 1
(On) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Alt If No Member -- if a member is not on duty,
intercom calls will be dropped and CO incoming calls
will be routed to the designated overflow destination,
or will ring at the assigned Station if the overflow
destination is not assigned.
PGM 191 + FLEX 12 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Music Source -- if a music source is assigned, user
will be able to hear music instead of a ring back tone
PGM 191 + FLEX 13 + 0
Music Source (refer to
Values) + [HOLD/SAVE]
VALUES --
0 = not assigned
1 = Internal Music
2 = External Music
3 = n/a
4-8 = SLT MOH
Release 3.5
June 2010