Technical data

External Device Control 1-97
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
To place the Doorbox in DND mode:
Press [DND].
Loud Bell
The Loud Bell Control (LBC) contacts are activated when the assigned station receives ringing
from an incoming or transferred call.
CONDITIONS
• Two LBC contacts can be assigned individually to a single station.
NOTE: Although the contacts may be assigned to the same station, only the first contact
will be activated for intercom calls.
• The LBC 1 can be programmed as an external night ring contact as well as a LBC contact.
• In Night Mode, LBC 1 follows the UNA ring assignment, and ignores the station ring.
• An external ringing device should be attached to the contacts.
ADMIN PROGRAMMING
Enable External Night Ring
Enable Universal Night Answer
Use PGM 141, then FLEX 8 … see page 1-133.
Enable External Control Contacts
External Night Ring -- if value is set to ON, when an incoming
CO call is received and UNA service is activated, the call will
be sent to LBC1.
PGM 160 + FLEX 7 + 0
(Off) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Loud Bell Control (LBC) -- if an External Control Contact is
assigned to LBC, it is activated. During night mode, LBC1
may be programmed to provide external night ringing. In
this case LBC1 does not follow the associated Station ring.
PGM 168 + FLEX 1
(Range: FLEX 1-FLEX 4)
+ 1 + Station Number +
[HOLD/SAVE]
VALUES --
1 = LBC (Sta #)
2 = Door
3 = Ext. 1
Door Open -- the External Control Contact can be used
when programmed to open a door.
PGM 168 + FLEX 1 + 2 +
[HOLD/SAVE]
External Relay -- the External Control Contact can be for
an External Relay.
PGM 168 + FLEX 1 + 3 +
[HOLD/SAVE]
Release 3.5
June 2010