Technical data

Conference Calls 1-91
Chapter 1: Basic System Features
SBX IP Programming & Operations Guide
CONDITIONS
• DID/DISA and transferred CO calls can join a conference room. However, in the case of
an analog line, a valid loop timer must be set (see ADMIN PROGRAMMING for this
feature) before DISA and transferred CO calls on that line can join a conference room.
• This feature terminates when the deactivation code is dialed or the "Forced Delete PGM"
code is used by the Attendant.
• The maximum number of conference rooms is 9. Each conference room can have a
maximum of 15 members.
• A password option can be assigned and set.
• A password is not required when deleting a conference room.
• For CO line participants, only an ISDN line can enter a conference room. A caller using a
Loop Start T1 trunk will not be permitted to enter a conference room.
• If the System Attendant station has a conference room button, its LED can be used to
check the status of conference room. If the LED is:
- ON (steady) - The conference room is activated, but no members have joined.
- OFF - The conference room is deactivated.
- Flashing at 60 ipm - 1 to 3 participants are currently in the room.
- Flashing 120 ipm - 4 to 6 participants are currently in the room.
- Flashing 240 ipm - 7 or more participants are currently in the room.
NOTE: If the Attendant Station does not have such a button, see “To check Conference
Room status from an Attendant Station” on page 1-90.
ADMIN PROGRAMMING
Enable/Disable Conference Warning Tone
Set Open Loop Timer
Use PGM 142, then FLEX 13 … see page 1-182.
Conference Warning Tone -- if value is set to ON, other
members will hear a warning tone when a new member enters
a conference.
PGM 160 + FLEX 11 + 1
(On) + [HOLD/SAVE]
VALUES --
0 = Off
1 = On
Release 3.5
June 2010