User guide

Using a Bluetooth Wireless Headset (IP-8024 only) B-4
Appendix B: IP PHONE SETUP
MBX IP Station User Guide
6. Press the NEXT Soft button,
7. Press the OK
soft button,
8. Enter the PIN code referring to the Bluetooth headset manual (default=0000),
9. Press OK
Soft button.
To unpair the BTU headset:
1. Set the Bluetooth headset to pairing mode,
2. Press the [TRANS/PGM] button,
3. Dial 63,
4. Dial 2 (disable),
5. Press the OK
Soft button.
To check BTU paired information:
1. Press the [TRANS/PGM] button,
2. Dial 63,
3. Dial 3,
4. Press the OK
Soft button.
To use the BTU headset:
1. Press the [SPEAKER] button,
OR
2. Press the "Call Start" button on the BTU headset,
3. Place call as you normally would.
To answer a call with the BTU headset:
1. When an incoming call is received, ringing will be present at the Station and the BT
headset,
2. Press the BT "Call Start" button, or press the [SPEAKER] button,
OR
3. Lift the handset.
NOTE: When the BTU is used for a call, the [SPEAKER] button LED will illuminate and the speaker
mode cannot be used. If the phone handset is taken off-hook while in BT mode, the voice path
will directly be connected to the handset; press the [SPEAKER] button to activate the BTU
headset.
Release 1.0
November 2010