User guide

Using Directory 2-6
Chapter 2: BASIC CALL HANDLING
MBX IP Station User Guide
Only an Attendant can assign System Speed Dial numbers.
To place a call using System Speed Dial:
1. Lift the handset,
2. Press the DIR Soft button,
3. Dial 2 for System Speed,
4. Dial the desired System Speed Dial bin number (200-999 for MBX IP-100, 2000-3999
for MBX IP-300.
Using and Entering Station Speed Dial Numbers
Each station in the MBX IP-100 System is allocated memory for 20 Station Speed Dial numbers
(bins 00-19) each up to 48 digits. The MBX IP-300 support 100 Station Speed Dial numbers
(bins 000-099). The MBX IP-100 & 300 each support 50 Station Speed Dial numbers (bins
000-049). These numbers are entered at the user's station and may include several "special"
instructions. Special instructions and the corresponding button are:
• PAUSE will momentarily stop dialing.
• FLASH as 1st digit-Activate dial tone detect.
• FLASH not as 1st digit-The system will generate a flash on the CO line.
• MSG as 1st digit-Send digits as ISDN Keypad Facility message.
• '*' as 1st digit-Display Security, the stored number will not be displayed when used.
• '*' not as 1st digit-Dial Pulse to Tone Switchover, the system will switch from pulse to
tone dialing.
When entering a Speed Dial, a 16 character name may be associated with the number for Dial
by Name. Characters are entered with two keystrokes as in the chart below.
To place a call using Station Speed Dial:
1. Lift the handset, and/or press the DIR Soft button,
2. Dial '1' for station speed,
3. Dial the desired Station Speed Dial bin number (00-19 , 000-099 or 000-049).
To enter a Station Speed Dial number with CO Line and Name:
1. Lift the handset, and/or press the DIR Soft button,
2. Dial '1' for station speed,
3. Press the ADD Soft button,
4. Dial the desired Station Speed Dial bin number,
5. Select/dial the CO/IP line/group,
6. Dial the desired number to be stored,
Release 1.0
November 2010