Installation guide

Basic Preprogramming 7-12
Chapter 7: Starting the MBX IP System
MBX IP Hardware & Installation Guide
IP Address
To program the IP Address to be used, perform the following Steps:
1. Press the [Trans/PGM] button.
2. Dial 108 (Program Number).
3. Press the FLEX1 button.
4. Enter the appropriate IP Address (up to 12 digits).
5. Press the [Hold/Save] button.
Network Mask Address
To program the Network Mask address:
1. Press the [Trans/PGM] button.
2. Dial 108 (Program Number).
3. Press the FLEX2 button.
4. Enter the appropriate Network Mask Address (up to 12 digits).
5. Press the [Hold/Save] button.
Gateway IP Address
To program the Gateway IP Address:
1. Press the [Trans/PGM] button.
2. Dial 108 (Program Number).
3. Press the FLEX3 button.
4. Enter the appropriate Gateway IP Address (up to 12 digits).
5. Press the [Hold/Save] button.
Firewall IP Address
To program the Firewall IP Address:
1. Press the [Trans/PGM] button.
2. Dial 108 (Program Number).
3. Press the FLEX4 button.
4. Enter the appropriate Firewall IP Address (up to 12 digits).
5. Press the [Hold/Save] button.
Release 1.7
April 2012