Installation guide

Basic Preprogramming 7-4
Chapter 7: Starting the MBX IP System
MBX IP Hardware & Installation Guide
5. Enter the three-digit program number; if an error is made while entering data, the
[TRANS/PGM] button will return to the previous status.
NOTE: To return the previous state while in ADMIN programming, press the [CONF]
button; pressing the [CONF] button will clear the temporary data fields.
Permanent Update Procedure
To commit data entered to permanent memory, perform the following steps:
1. When data has been entered, press the [HOLD/SAVE] button to permanently store
the data; if all data was entered correctly, a confirmation tone will be heard.
2. If there were any errors in the entry, an error tone will be presented and data is not
stored in the permanent memory, and the terminal will return to the previous state.
How to Reset the System
To reset the system:
1. Press the [Trans/PGM] button.
2. Dial 499 (Reset System Code).
3. Press the FLEX2 button.
4. Press [HOLD/SAVE]. NOTE: The system should be reset after entering PGM100 -
FLEX 1 (Nation Code Assign).
Pre-programming
LOCATION PGM-NATION CODE & SITE NAME (PGM100)
When programming, the 'MODE' switch on the MPB100/300 should be set to ON.
Nation Code
To program the Nation Code, perform the following steps:
1. Press the [Trans/PGM] button.
2. Dial 100 (Program Number).
3. Press the FLEX1 button.
4. Enter the appropriate Nation code.
Release 1.7
April 2012