Installation guide

Basic Preprogramming 7-2
Chapter 7: Starting the MBX IP System
MBX IP Hardware & Installation Guide
Basic Preprogramming
The MBX IP System can be programmed to meet each customer's individual need. This section
contains the following topics:
- Before ADMIN programming
- Button explanation
- How to enter the programming mode
- Permanent update procedure
- How to reset the system
Before Admin. Programming
There are two ways to access and perform Admin. Programming functions:
Web ADMIN (refer to the MBX IP Web Admin. Programming manual)
DKTU (Station 100) Admin. Programming
All DKTU programming is conducted at Station 100 (MPB100/MPB300 DKT1 port) using a
LDP-7024D, KD-36D, or LKD-30/44 digital key telephone.
Additional programming stations may be assigned (PGM 121 - FLEX 5), but only 1 DKTU can
be active in the programming mode by default.
Upon entering Programming mode, Station 100 cannot operate as a normal telephone but as
a programming instrument with all of the buttons redefined. The keys of the dial pad are used
to enter the various data fields and to enter numerical information. The buttons located at the
side of the phone (Flexible Buttons) are used to indicate the specific data field and to enter
information. If the keyset doesn't have 3 soft buttons, the [SPEED] button is used to delete the
data and the [CONF] button is used to move to upper step.
Release 1.7
April 2012