Installation guide

Introduction 6-2
Chapter 6: DECT Installation
MBX IP Hardware & Installation Guide
The following is needed to configure the System using DECT phones:
• WTIB4, WTIB8 board - Up to three WTIB4s or WTIB8s can be connected to the MBX
IP System. Each WTIB4 and WTIB8 can support up to 4 or 8 Base Stations
(respectively).
• Base Station (GDC-400B) - Each Base Station can process up to four simultaneous
calls. The Base Station should be installed indoors and protected from surge because
it is designed to be an indoor Base Station.
OR
• Base Station (GDC-600B) - The Base Station can process up to six simultaneous
calls. The Base Station should be installed indoors and protected from surge because
it is designed for indoor station.
• Wireless Terminal (GDC-33xH, 34xH, 400H) - Up to 192 wireless terminals can be
registered (refer to the DECT Wireless Terminal User Guide).
Base Station Specifications
Wireless Terminal Specifications
ITEM SPECIFICATION
Power Feeding +30V DC
Transmission Max Power 250mW
Access Method/Duplex TDMA/TDD
Frequency Band 1,880 - 1,900MHz
Channel Spacing 1.728MHz
Modulation GFSK
Data Rate 1.152Mbps
Max. Base Station distance from the WTIB4/8 600m (twisted 2-pair cable)
ITEM SPECIFICATION
Max. Transmission Power 250mW
Modulation Method GFSK
Frequency Band 1,880MHz - 1,900MHz
T
h
i
s
fe
a
t
u
re
i
s
n
o
t
a
v
ai
l
ab
l
e
a
t
t
h
i
s
t
i
me
.
.
.
T
h
i
s
fe
a
t
u
re
i
s
n
o
t
a
v
a
i
l
a
b
l
e
a
t
t
h
i
s
t
i
me
.
.
.
Release 1.7
April 2012