User guide

Using Answering Machine Emulation (AME) 3-2
Chapter 3: RECEIVING CALLS
MG IP Station User Guide
Respond to any of these Off-hook Signals in one of several ways; place the existing call on Hold
and respond to the new incoming call, activate One-time DND, send a Silent Text Message, or
ignore the new call.
Silent Text Message requires a TEXT MESSAGE button (not available on a SLT or other
non-display terminal).
The Attendant or Secretary may use Intrusion to announce a call while you are busy.
To answer a Call Waiting:
Press HOLD/SAVE,
AND/OR
Press the flashing CO/IP LINE button.
To activate One-time DND:
Press the DND button.
To send a Silent Text Message:
Press the programmed TEXT MESSAGE button, then select the desired message to
send.
Using Answering Machine Emulation (AME)
When a call is connected to your voice mail, you can screen the call as with a normal Answering
Machine. The caller's voice is played over your speaker while the message is being recorded.
There are two methods of notification and call screening provided, LED blink mode or Speaker
hearing mode.
• LED Blink Mode - the Answering Machine Emulation (AME) Flex button will flash to
notify you of a call. You may press the Flex button to hear the caller as the voice
message is stored.
• Speaker Hearing Mode - when the call is sent to the voice mailbox, the caller's voice is
automatically broadcast over the speaker of your MBX Phone.
You may terminate screening, leaving the caller in voice mail to record a message, talk with the
caller and record the conversation in the mailbox, or answer the call and disconnect the
Voicemail.
The AME feature is only available when using the MBX VMIB Voice Mail; a MUTE and AME
button should be programmed (refer to Appendix A User Program Codes).
CONFIDENTIAL MATERIAL - Do Not Distribute
1.0 Review Draft - 7/7/2010