User guide

Wall Mount 1-5
Chapter 1: INTRODUCTION
MBX IP Station User Guide
Wall Mount
The IP-8000 series phones can be wall mounted as needed. The following instructions describe
how to perform a wall mount installation. For more information on installing your IP-8000 series
phone, refer to the MBX IP Hardware Description and Installation Manual.
1. Mark and drill two (2) 7mm holes for plastic wall anchors.
2. Insert the two (2) anchors into the holes and insert and tighten the each screw leaving
about 2.5 mm (1/8-inch) of the screw exposed.
3. Slide the IP-8000 phone over the screws and assure the phone is secure.
NOTE: It may be necessary to remove the phone and tighten or loosen the screws for a
secure mounting.
CONFIDENTIAL MATERIAL - Do Not Distribute
1.0 Review Draft - 7/7/2010