User guide

Wiring Connectors 1-4
Chapter 1: INTRODUCTION
MBX IP Station User Guide
Wiring Connectors
The IP-8012 & IP-8024 each have two (2) 10/100 Base-T Ethernet ports, a "LAN" port and a
"PC" port. An intelligent switch, which implements voice packet priority, connects the two (2)
ports. This permits the LAN to be shared between the LIP Phone and the desktop PC or other
Ethernet terminal without significant affect on the voice or data traffic. The "LAN" port is
connected to the LAN as described above for the single port Phones. The "PC" port is
connected to a desktop device using any standard straight through category 5 cable.
Power
All IP-8000 series phones can be powered by the AC/DC Adapter-K- (48 VDC @0.3A) or over
the LAN cable using the POE8 or other 802.3af compliant switch.
If using the AC/DC Adapter, after connecting the Phone to the LAN, the Adapter's DC voltage
plug is inserted into the power-input jack in the underside of the Phone. One end of the AC
power cord is inserted into the mating receptacle of the AC Adapter, and the other end is
inserted into the AC power outlet.
NOTE: IP-8000 series consoles are powered through the flat cable used to connect the console to the
IP phone (shown). Up to 2 (without IP-8048DSS) or 4 (with IP-8048DSS) consoles can be
chain-link connected to the phone.
DSS Connection to IP Phone
CONFIDENTIAL MATERIAL - Do Not Distribute
1.0 Review Draft - 7/7/2010