User guide

Voicecall 3-62
Using Wave Phone Features
Wave Phone User Guide
From an idle phone:
1. Decide which button you want to program.
2. Press the
MENU softkey on the display.
3. Press
NEXT until PROG appears, then press the corresponding button.
4. Press
Next until the desired feature is displayed, then press the corresponding
button.
5. Press the button you wish to program.
If additional options are available (such as an extension for User Forward or Blind
Transfer for DSS/BLF) you will be prompted at this point to enter the information.
6. Press SPEAKER to clear the display.
To Clear a Feature Button
Follow the above steps, and program the button as “Unassigned”.
Using the Query Feature (phone models with displays only)
A query of a feature button will display what feature has been programmed onto the button.
To Display Feature Information
From an idle phone:
1. Press the MENU softkey on the display.
2. Press a feature button.
The feature button information is shown on the display including the feature name,
button number, and extension number, target number, or programmed number if
applicable.
3. Press SPEAKER to clear the display.
Voicecall
Voicecall is a page directed to a specific digital phone extension that allows the receiving party
to reply.
Note: Typically, a phone has only one Voicecall button which requires input of an extension
number to be dialed and paged. However, additional Voicecall buttons may be programmed on
a phone to allow direct calls to other specific extensions. One possible example of the use of
multiple VoiceCall buttons might be a supervisor who has a Voicecall button with the standard
operation as shown below, as well as additional buttons that correspond to the supervisor’s
assistant or other members in their group for direct paging purposes. When entering an
extension number is not required, the page is placed directly.
Release 1.5 SP3
September 2009