User guide

Joining a Call 3-42
Using Wave Phone Features
Wave Phone User Guide
DIGITAL PHONES (8012/8024 ONLY)
To Make an Intercom Call
1. Press Intercom.
2. Dial the extension.
To end the call:
3. Press Intercom or hang up.
Joining a Call
When a line appearance on your phone is in use by another party, the LED next to the
corresponding button indicates whether you can join that call.
• A Red LED indicates that Break-in is blocked.
• A flashing green LED indicates that Break-in is allowed.
Note: Also see “Supervising Calls (Monitor/Coach/Join)” on page 3-55.
Using the Call Break-in Feature [D]
DIGITAL PHONES
Note: Some outside lines can carry more than one call at a time. Break-in is not allowed on
those outside lines. Ask your System Administrator if this applies to your system.
To Join a Call
Press the line button that corresponds to the call with a flashing green LED.
Note: The Edge 700 - 8 button phone utilizes red LED lights only on pre-programmed
buttons.
Message Waiting
If you have a Message Waiting button, the corresponding LED flashes when there are new
Voicemail messages.
Note: On SIP and Analog phones, when there are new Voicemail messages, you will hear a
stutter tone when you select your primary line button.
Release 1.5 SP3
September 2009