User guide

Hold 3-40
Using Wave Phone Features
Wave Phone User Guide
DIGITAL PHONES
To Place a Call on Hold
Press HOLD.
When a call is on hold, the red LED flashes next to the corresponding line or call
appearance button.
You can hang up the handset or use other phone features.
If you leave the call on hold for longer than the system hold time (three minutes is the
default), your phone rings back and
HELD is displayed.
Note: The Flash button can be used to place calls on temporary hold. When you do so,
you will hear dial tone. If you press Flash again or hang up the handset, you will be
reconnected to the call on hold.
To Reconnect to a Call on Hold
Press the line or call appearance button that corresponds to the call that was
placed on hold.
or,
Press the TAP button to retrieve the most recently held call.
Hint: If more than one call has been placed on hold, and the phone is not currently
connected on a call, you can press the HOLD button repeatedly to scroll through all the
calls currently on hold. When the desired call is shown on the display, press TAP to
retrieve that one.
ANALOG PHONES
Place the current call on hold while you use other phone features.
To Place a Call on Hold
With a party on the line:
1. Press FLASH, then #, then *64.
or,
Press FLASH, then 7.
2. Listen for two beeps.
3. Hang up.
Release 1.5 SP3
September 2009