User guide

Hold 3-39
Using Wave Phone Features
Wave Phone User Guide
To Unpair the Bluetooth®
Follow steps 1 and 2 above, then in step 3, select 2 to “unpair” the Bluetooth® device. The
system will search for the device and, if successful, a “
DEVICE DE-REGISTERED” will be
displayed.
Hold
You can place a call on hold to keep the other party connected while you hang up the handset
or use other phone features.
Placing a Call on Hold [ALL]
SIP PHONES
To Place a Call on Hold
Press Hold ( ) on models 9112i, 9133i, and 9143i or the button labeled Hold
on 480i/CT, 9480i/CT, and all Aastra Series 5 models.
The LED flashes next to the line button with a call on hold.
You can hang up the handset or use other phone features.
If you leave the call on hold for too long, your phone rings back to
remind you.
Note: The Flash button can be used to place calls on temporary hold. When you do so,
you will hear dial tone. If you press TAP, you will be reconnected to the call on hold; if you
hang up the handset the call on hold will immediately recall.
To Reconnect to a Call On Hold
Press the button corresponding to the line at which the call was placed on hold.
Using the Reconnect Softkey (Models 480i/CT and 9480i/CT only)
Use the
RECONNECT softkey to reconnect to a call that is on hold or parked.
Release 1.5 SP3
September 2009