User guide

Conference Calls 3-25
Using Wave Phone Features
Wave Phone User Guide
To Make a Conference Call with Feature Codes
During a call:
1. Press Flash to place the other party on hold.
2. Listen for the dial tone, then dial the extension of the third party.
When the third party answers:
3. Press Flash and dial *71 to connect the calls.
• If a party is not available, press Flash and dial *72 to reconnect to the first party.
• If a party’s Voicemail answers, or the party does not want to join the conference,
press End Call.
• For 480i/CT, 9480i/CT, and all Aastra Series 5 models: press Goodbye ( to
drop the call and rejoin the first party.
4. Press Flash again to place the conference call on hold and to add a fourth party.
5. Press Flash and Dial *71 to connect the fourth party to the conference.
To Disconnect from a Conference Call
Hang up the handset, or press End Call
• For 480i/CT, 9480i/CT, and all Aastra Series 5 models: press Goodbye ( or use
the
DROP softkey.
DIGITAL PHONES
Since all Wave Digital phones have a hard-coded TRNS/CONF or TRANS button, a programmed
Conference feature button is not required. However, such a feature button is supported for
backwards compatibility.
The functionality between such a button and the TRNS/CONF (or TRANS) button is identical.
Therefore, you can use the steps below substituting the feature button for the TRNS/CONF (or
TRANS) button.
To Set Up a Conference
During a call:
1. Press TRNS/CONF or TRANS button to place the other party on hold.
The HOLD button LED flashes red.
2. Listen for the dial tone, then dial the number of the next party.
Release 1.5 SP3
September 2009