User guide

Call Park 3-6
Using Wave Phone Features
Wave Phone User Guide
Call Park
Use Call Park to place a call on hold for retrieval from any phone on the system.
Directed Park [ALL]
Directed Park allows you to park a call on another line. A specific extension number may be
programmed on your Directed Park button to allow you to always park a call on a specific line.
SIP PHONES
To Direct Park a Call
With a party on the line:
1. Press Flash, then *66.
2. Dial the extension.
3. Listen for two beeps.
4. Hang up.
To Retrieve a Direct Parked Call
1. Listen for the dial tone.
2. Press *65.
3. Dial the extension.
DIGITAL PHONES
To Direct Park a Call
While on an active call:
1. Press the pre-programmed Directed Park button.
If your phone does not have a programmed Directed Park button, press Flash, then *66
to park a call.
2. Enter an extension number, as needed.
3. Listen for two short beeps, then hang up.
If the button is configured to display the status of the parked call, the green LED will
flash until the call is unparked. If the call does not get answered, you can retrieve the call
by pressing the Directed Park button. You can use the button to park another call on
another line even if the green LED is flashing.
Note: The Edge 700 - 8 button phone utilizes red LED lights only on
pre-programmed buttons.
Release 1.5 SP3
September 2009