Programming instructions

- 73 -
DX-120 Programming Manual BASIC SYSTEM PROGRAMMING TASKS
Programming CID Names and Assignments Table via PC-DBA (continued)
1) Go to ProgrammingXSystem ResourceXCID Name Table Assignment and Programming to display the
CID Name Table Assignment and Programming screen.
2) Select the tenant for which you want to program CID information.
3) Decrease or increase (if there is sufficient room) the number of caller ID names in the table as needed
(and if there is sufficient room).
• The range is 0 to 100, selectable in increments of 10.
• The default is 100 for tenant group 1, and 0 for tenant groups 2 and 3.
NOTE
• 100 is the maximum number of caller ID entries available for the system as a
whole.
• To assign some of them to tenant groups 2 and 3, you must decrease the number
available to tenant group 1.
Programming CID Names and Assignments Table via PC-DBA (continued on next page)