Programming instructions

BASIC SYSTEM PROGRAMMING TASKS DX-120 Programming Manual
- 70 -
Programming Speed Dial Numbers via the DET (continued)
Programming the Number of System Speed Dial Numbers Allowed per Tenant:
Use this process to program speed dial numbers for use by any extension user on the DX-120 system.
From the DB Item Select screen (see steps 1 through 3 on page 69):
4) Enter 04-08-02.
5) Press save to display the Assignment for System Speed Dial numbers screen.
6) Press show.
7) Enter the tenant group number you want to change (usually tenant group 1).
8) Press show to advance to the Increase screen for this Tenant Group System Speed List.
9) Press chg to increase the number of allocated speed dial numbers (in increments of 50).
• The range of allowable speed dials is 0 to 1000.
• The default is 200.
OR
Press next to advance to the Decrease screen for this Tenant Group System Speed List.
10) Press chg to decrease the number of allocated speed dial numbers (in increments of 50).
11) Press next to enter a new tenant group and continue programming.
12) Press the Hold button to return to the previous menu level.
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Program the System Speed Numbers:
From the DB Item Select screen (see steps 1 through 3 on page 69):
4) Enter 04-09-X (where X represents the tenant group: 1~3).
5) Press save to display the the system speed dial entry point for the tenant group you specified.
6) Enter the speed dial number to program (500-699).
7) Press show to display the current stored number.
8) Press chg to change this stored number.
9) Enter the new telephone number (using special characters as required).
- Pause = Feature 7 0
- Flash = Feature 3
- Pulse-To-Tone Conversion = *
- Speed Numbering Chaining = Feature # + next speed number (500~699).
Programming Speed Dial Numbers via the DET (continued on next page)