Programming instructions

- 67 -
DX-120 Programming Manual BASIC SYSTEM PROGRAMMING TASKS
Programming Speed Dial Numbers via PC-DBA (continued)
Once you have assigned a maximum number of system speed dials to each tenant group:
4) Click on the desired speed dial the in the System SPD scroll list.
• The appropriate line will also be highlighted in the scroll list above) from the DIR # field.
5) Click in the SPD. No. field and type the number you wish to associate with this speed dial.
• Use special characters as required.
- Pause = P
- Flash = / (forward slash)
- Speed Numbering Chaining = @ + next speed number (500-699).
6) Enter the group number you want associated with this speed dial number.
• Valid choices are from 1 to 8.
• The default is 1.
7) Click to move the number into the scroll list.
• The default for all system speed dials is blank.
• Use this same procedure to program as many system speed dial numbers as needed (up to the limit
you assigned to each tenant group).
Once you have programmed all of the speed dial numbers, go to the Extension SPD area:
8) Select the Extension you wish to program.
9) Select the number of speed dial numbers you want to allow for the currently selected extension from the
Number of SPD. (for Extension) field.
• The range of allowable speed dials per extension is 0 to 50, in increments of 10. The default for
extensions 101-140 is 20.
• The default for all others is 0.
• Use this same procedure to program to allocate the appropriate number of speed dials for each
Extension.
NOTE
If the system will not allow you to assign speed dials to an extension, decrease the
number assigned to one or more of the other extensions, then try again.
Programming Speed Dial Numbers via PC-DBA (continued on next page)