Programming instructions

BASIC SYSTEM PROGRAMMING TASKS DX-120 Programming Manual
- 66 -
Programming Speed Dial Numbers via PC-DBA (continued)
1) Go to ProgrammingXSystem ResourceXSPD.No.Assignment and Programming to display the
SPD.No.Assignment and Programming screen.
In the System SPD area:
2) Select the Tenant group you wish to program.
3) Select the number of speed dial numbers you want to assign to the currently selected tenant group from
the Number of SPD (for Tenants) field.
• When you first select a tenant group (see step 2 above), the field displays the number of speed dial
numbers currently assigned to each tenant group.
You can decrease or increase (if there is sufficient
room) the number of speed dials available to the tenant group.
• The valid range is 0 through 1000, in multiples of 50.
• The defaults are 200 for tenant group 1, and 0 for tenant groups 2 and 3.
• Assign the number of speed dials for each tenant group as necessary by following the steps above.
NOTE
There is a maximum number of speed dials available for the system as a whole. If
you cannot assign any to tenant groups 2 and 3, decrease the number available to
tenant group 1, then try again.
Programming Speed Dial Numbers via PC-DBA (continued on next page)