Programming instructions

BASIC SYSTEM PROGRAMMING TASKS DX-120 Programming Manual
- 58 -
Naming CO Lines
The DX-120 allows you to name (or label) CO lines so you can customize the appearance of the line identifier in the
telephone display when the CO line is in use.
This labeling can assist users when handling CO line calls by displaying
the intended purpose of that CO line.
NOTE
• Valid names can have up to 7 alphanumeric characters.
• The default names are "Line 1" through "Line 40," corresponding to directory
numbers 800 through 839.
• Directory Numbers 840 through 843 are reserved for future use.
NAMING CO LINES VIA PC-DBA
From the PC-DBA main screen:
1) Go to ProgrammingXSystem ResourceXCO Line Names to display the CO Line Names screen.
In the table at the top of the screen
1) Click on (to select) the line to which you wish to assign a name.
Naming CO Lines via PC-DBA (continued on next page)