Programming instructions

BASIC SYSTEM PROGRAMMING TASKS DX-120 Programming Manual
- 54 -
Setting System Time, Date, and/or Hour Mode (continued)
Change the Hour:
You can continue from step 6 above or:
From the Select screen (see steps 1 through 3 on page 52):
4) Enter 08-14-05 to display the hour.
5) Press chg.
6) Enter 2 digits for the hour.
HINT
Hours must be entered using the military format and must always be entered as 2
digits: 1pm must be entered as 13, 2pm would be entered as 14, etc.
7) Press save to store the setting.
8) Press next to go to the month setting (now go to step 5 “Change the Minutes” below).
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Change the Minutes
You can continue from step 8 above or:
From the Select screen (see steps 1 through 3 on page 52):
9) Enter 08-14-06 to display the minutes.
10) Press chg.
11) Enter 2 digits for the minutes.
HINT
You must always use a two-digit format: if you want to set the minutes at 5 after the
hour, you would need to enter it as 05.
12) Press to store the setting.
When you are finished:
13) Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).