Programming instructions

- 419 -
DX-120 Programming Manual BASIC EXTENSION PROGRAMMING TASKS
Setting Up Paging Privileges
Extension users can perform several types of page announcements:
• Internal Paging - they can page a group or place a system-wide internal page.
• External Paging - they can access external ancillary paging equipment.
• All Call Paging - they can access all paging zones (internal and external).
• Extension users can also respond to a page announcement using Meet Me Paging. In this case, they dial a meet
me page code upon hearing their name paged. The system then establishes a private connection to the paging
extension.
• Paging is one-way only.
• The Page Allow/Deny setting does not interfere with an extension’s ability to make
• a page or to establish a meet me page.
• The following conditions apply to paging privileges:
- The display will show PAGE FAILURE if a page fails due to that page group/zone being busy.
- You can assign any of the paging codes to a programmable feature button.
- The external pager port can be programmed to operate with any page group via system resource – external
pager programming.
• To make a page announcement, extension users have to enter the page code. At default the page codes are as
follows:
- 400 = tenant all call
- 401~408 = page groups (zones) 1 through 8
- 777 = external pager.
NOTE
It is recommended that all page announcements be made using the handset to
reduce potential audio feedback and oscillation (squeal).
HINT
If you want to allow external paging for an extension, be sure external paging
(see
“Assigning External Page” on page 77) has already been set up and
assigned to the paging group you want to use.
SETTING UP PAGING PRIVILEGES VIA PC-DBA
From the PC-DBA main screen:
Setting Up Paging Privileges via PC-DBA (continued on next page)