Programming instructions

- 397 -
DX-120 Programming Manual BASIC EXTENSION PROGRAMMING TASKS
Assigning Extensions to Paging Groups
The system provides eight extension paging groups per tenant group to allow you to partition the system into separate
departments for page announcements.
• Extension users can also respond to a page announcement using Meet Me Paging. In this case, they dial a meet
me page code upon hearing their name paged. The system then establishes a private connection to the paging
extension.
• Paging is one-way only.
• The Page Allow/Deny setting does not interfere with an extension’s ability to make a page or to establish a meet
me page.
• The following conditions apply to paging privileges:
- The display will show PAGE FAILURE if a page fails due to that page group/zone being busy.
- You can assign any of the paging codes to a programmable feature button.
- The external pager port can be programmed to operate with any page group via system resource – external
pager programming.
- To make a page announcement, extension users have to enter the page code.
• At default the page codes are as follows:
- 400 = tenant all call
- 401~408 = page groups (zones) 1 through 8
- 777 = external pager.
NOTE
It is recommended that all page announcements be made using the handset to
reduce potential audio feedback and oscillation (squeal).
Assigning Extensions to Paging Groups (continued on next page)