Programming instructions

- 31 -
DX-120 Programming Manual SHORTCUTS THAT HELP YOU WORK FASTER
Copy the Programmed CO Line Setup via PC-DBA (continued)
Copy a CO Line Setup to All the Lines in a Line Group
2) Locate the Group area under CO Line Copy.
3) Select the CO line directory number you want to use as a baseline from the dropdown list in the Source
DIR No. field.
• Valid directory numbers are 800 through 839.
• There is no default.
4) Select the CO group number into which you want to copy the baseline’s programming (9 and 740 through
746) in the CO Group field.
5) Click Copy to make the specified copy.
• Enter any other CO group numbers as needed using the steps above.
Now... continue on to step 6 below.
When all copies have been made:
6) Click the Update button to enter and save your settings into the database on your local disk.
7) Click the Close button to exit the current screen and return to the PC-DBA main screen.
Once all database changes have been completed:
8) Perform a SEND to copy the database changes to the DX-120 switch system memory.
COPYING BASELINE CO LINE SETUPS VIA THE DET
PROGRAM THE CO LINE SETUP TO BE COPIED
See “Section 5 - Programming C.O. Lines” for additional information about programming C.O. lines
COPY THE PROGRAMMED CO LINE SETUP
NOTE
• chg, bksp, save, one, always, del, and ack are interactive LCD button operations.
Use the three buttons below the LCD display to activate the associated operation.
• You can press Hold at any time to return to the previous level or press the volume
buttons to return to the main DB selection screen.
1) Enter Database Administration (see page 26) using the feature code Feature # * to display a prompt for
the password.
2) Enter the DB Admin password.
Copy the Programmed CO Line Setup via the DET (continued on next page)