Programming instructions

PROGRAMMING THIRD PARTY VOICE MAIL DX-120 Programming Manual
- 376 -
Set the Call Handling Digits via the DET (continued)
Programming VM Table – Delete Digit:
From the DB Item Select screen (see steps 1 through 3 on page 370):
4) Enter 06-02-0X-05 (where X is the Tenant Group: 1~3).
5) Press save to display the Delete Digit screen.
6) Press chg.
7) Enter the numbers you want the system to use to delete the current recording for this mailbox owner.
8) Press save to store the setting.
9) Press next to continue programming the various call handling digits VM Table - Disconnect Digit (now go
to step 6 in the next section).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming VM Table – Disconnect Digit:
From the DB Item Select screen (see steps 1 through 3 on page 370):
10) Enter 06-02-0X-06 (where X is the Tenant Group: 1~3).
11) Press save to display the Disconnect Digit screen.
12) Press chg.
13) Enter the numbers you want the system to use to to force disconnect of the active port.
14) Press save to store the settings.
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Now, set the Voice Mail Dialing Ratio (see page 379)