Programming instructions

PROGRAMMING UCDS DX-120 Programming Manual
- 346 -
Programming UCDs via PC-DBA (continued)
2) Select/enter information up in the fields as described below:
UCD PROGRAMMING FIELDS
FOR THIS FIELD... DO THIS...
Hunt Group
Select the hunt group for which you are defining UCD parameters.
• Valid entries range from 410 to 433.
• The default is 410.
Attribute
Select UCD or VA. Use the VA option if you are using extensions on a RAD
for overflow destinations.
NOTE
If you expect high traffic on a third-party RAD device, program VA
analog ports into an available UCD group, and then set that UCD
group Attribute field to VA.
Tenant Group
Assign this UCD to a tenant group.
• Valid options are 1, 2, and 3. If your system is not divided into tenant
groups, use 1.
• The default is 1.
Name Enter the name you want to use for this UCD group.
Hunting Method
Select the hunting method you want to use for this UCD group.
• Valid options are Linear, Distributed, and All Ring.
• The default is Linear.
No Answer Timer
Select how long you want the system to ring an extension in this UCD group
before pulling the call back and ringing the next extension in the hunt group.
• Valid options are 5 to 60 seconds.
• The default is 10.
Overflow 1 Timer
Enter the length of time (in seconds) that you want a call to remain in the
queue before the system routes it to the overflow 1 destination.
• Valid options are 0 to 255 seconds.
• The default is 0
Overflow 1 Dest.
Enter the UCD directory number to which you want the system to send the
queued caller when the overflow 1 timer has expired.
• Valid options include any valid extension or UCD directory number.
• The default is blank (no destination).
• If the destination is a third-party RAD device that is connected to a DX-120
analog port, enter that port number here.
• If the destination is the DX-120 optional integrated voice mail, set this field
to extension 433.
UCD Programming Fields (continued on next page)