Programming instructions

BASIC TOLL RESTRICTION PROGRAMMING TASKS DX-120 Programming Manual
- 340 -
Setting the Account Code Length and Password via the DET (continued)
Temporarily Disable the Account:
This setting is used temporarily to disable the use of a particular account code without removing its programming.
From the DB Item Select screen (see steps 1 through 3 on page 338):
4) Enter 05-02-02-XXX-03 (where XXX represents the row in the account code table: 001~600).
5) Press save to display the Disable Account screen.
6) Press chg to select Y (disabled) or N (enabled).
7) Press next to display the CO Group screen (now go to step 6 in “Setting the CO Group for the Account:”
below).
8) Press the Hold button to return to the previous menu level.
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting the CO Group for the Account:
From the DB Item Select screen (see steps 1 through 3 on page 338):
4) Enter 05-02-02-XXX-04 (where XXX represents the row in the account code table: 001~600).
5) Press save to display the CO Group screen.
6) Press chg until the CO Group number you want appears.
• Valid choices are 1~8.
• The default is 1.
7) Press next to display the ID Number screen.
• You can then enter the appropriate ID and continue to program for the next item.
OR
Press the Hold button to return to the previous menu level.
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).