Programming instructions

- 317 -
DX-120 Programming Manual BASIC CALL HANDLING PROGRAMMING TASKS
Setting DISA via the DET (continued)
Setting the CO LN:
From the DB Item Select screen (see steps 1 through 3 on page 315):
4) Enter 03-47-03.
5) Press save to display the CO LN screen.
6) Enter the CO line directory number.
• Valid entries are from 800 to 839.
• The default is 800.
IMPORTANT!
• When a T1 or ISDN (T1/PRI) is in use, valid entries are 816 through 839. When
any of these are selected, the DISA Line checkbox is automatically checked
(enabled) by default.
• DO NOT CHANGE THIS SETTING IF YOU ARE USING T1 OR ISDN (T1/PRI).
This setting must remain CHECKED.
7) Press show to display the DISA CO LINE (Y/N) screen (now go to step 6 in “Programming the DISA CO
LINE:” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming the DISA CO LINE:
From the DB Item Select screen (see steps 1 through 3 on page 315):
4) Enter 03-47-03-XXX-01 (where XXX represents the appropriate directory number: 800~839).
5) Press save to display the DISA CO Line.
6) Press chg to select Y (yes) or N (no).
• The default is no.
7) Press next to display DISA DAY COS (now go to step 6 in “Programming the DISA DAY COS:” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting DISA via the DET (continued on next page)