Programming instructions

BASIC CALL HANDLING PROGRAMMING TASKS DX-120 Programming Manual
- 264 -
Programming Caller ID Codes and Local Calling Areas
The DX-120 allows you to program and store information for use in dialing outgoing calls. You can specify area codes
as well as international code so that they are automatically used when dialing corresponding telephone numbers.
• The following conditions apply when programming the caller ID table:
- You must properly program the local area code and long distance prefix so the system can accurately re-dial
the CID number from the caller ID table.
- If no name is delivered from the telephone company, the system displays the number only.
- Any digital speaker phone user can review the caller ID table if the attendant password is known, but the table
can be reviewed by only one telephone at a time.
- You can exit the caller ID call table mode at any time.
• When programming the caller ID table, enter the following:
- International prefix (typically not required in the USA or Canada).
- Country code (typically not required in the USA or Canada).
- Long distance prefix (usually 1).
- Local area codes (enter them as the prefix if the local phone company uses 10 digit dialing).
HINT
Also see...
• “Programming CID Names and Assignments Table” on page 72.
• “Programming Caller ID Codes and Local Calling Areas” on page 264.
PROGRAMMING CALLER ID CODES AND LOCAL CALLING AREAS VIA PC-DBA
From the PC-DBA main screen:
Programming Caller ID Codes and Local Calling Areas via PC-DBA (continued on next page)