Programming instructions

- 13 -
DX-120 Programming Manual PROGRAMMING VIA PC-DATABASE ADMINISTRATION (PC-DBA)
Database Save and Restore (continued)
RESTORING (OPENING) A STORED DATABASE
From the PC-DBA main screen:
1) Go to FileXOpen Database... to display the Open dialog box.
• This dialog box allows you to select the desired database file.
2) Select (or enter the name of) the database you wish to restore.
3) Click Open to open the specified database.
• The system will use this database file until you specify a different name or close the application.
Connecting PC-DBA to the Switch
When using the programming options of PC-DBA, there are times when you need to send and receive information
between PC-DBA and the switch. However, before data can be exchanged between the PC and the DX-120 system,
you must make a connection between the two devices.
This connection is a serial (RS-232 – COM port or modem)
link.
There are specific tasks that can only be performed after a successful connection between PC-DBA and the switch has
been made:
• Receiving (data from the switch) - see page18
• Sending (data to the switch) - see page19
• Initializing the System (cold and warm starts) - see page21
• Diagnostics and T1 Maintenance - see page480
•
HINT
Also see...For specific information about making a physical connection between
PC-DBA and the switch, be sure to review the Vertical DX-120 Installation and
Maintenance Manual available on the Vertical CCC web site (www.vertical.com/ccc).
Connecting PC-DBA to the Switch (continued on next page)