Programming instructions

PROGRAMMING FOR THE OPTIONAL T1 AND ISDN (T1/PRI) CARDS DX-120 Programming Manual
- 174 -
Programming for the Translation Table via the DET (continued)
Setting the Interceptor:
From the DB Item Select screen (see steps 1 through 3 on page 173):
4) Enter 07-05-02.
5) Press save to display the Intercept screen.
6) Press chg.
7) Enter the extension that you want the C.O. to use when a matching DID cannot be found in the
Translation Table (using digits 0-9).
8) Press save to store the setting.
9) Press next to display the previous Translation Table programming screen.
10) Enter XXX (where XXX represents the appropriate table row number: 001~ 100. Now, go to step 6 in “Setting the
Incoming Number” below)
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting the Incoming Number
From the DB Item Select screen (see steps 1 through 3 on page 173):
4) Enter 07-05-03-XXX (where XXX represents the appropriate table row number: 001~ 100).
5) Press save to display Incoming number screen.
6) Press chg.
7) Enter the DID number for which you want to program incoming modes (using digits 0-9).
8) Press save to store the setting.
9) Press next to display the Day Destination screen (now go to step 6 in “Setting the Day Service Mode:”
below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming for the Translation Table via the DET (continued on next page)