Programming instructions

- 173 -
DX-120 Programming Manual PROGRAMMING FOR THE OPTIONAL T1 AND ISDN (T1/PRI) CARDS
Programming for the Translation Table via the DET (continued)
SETTING UP THE TRANSLATION TABLE VIA THE DET
See Field Descriptions beginning on page 172 for more information about the settings via the DET.
NOTE
• chg, bksp, save, one, always, del, and ack are interactive LCD button operations.
Use the three buttons below the LCD display to activate the associated operation.
• You can press Hold at any time to return to the previous level or press the volume
buttons to return to the main DB selection screen.
• You can also use steps from “Programming for a ISDN (T1/PRI) Card via the DET”
on page 167, to access the Translation Table.
1) Enter Database Administration (see page 26) using the feature code Feature # * to display the password
prompt.
2) Enter the DB Admin password (see page 27).
3) Press show to display the DB Item Select screen.
4) Enter 07-05.
5) Press save to enter Translation Table programming.
6) Press show to display each Translation Table screen (see information in the following sections for setting
up the Translation Table - see table on page
172 for details about each of these settings).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting DID Length:
From the DB Item Select screen (see steps 1 through 3 above):
4) Enter 07-05-01.
5) Press save to display the Length setting.
6) Press chg until the number of digits you want the system to send to the switch (i.e., 1 - 12).
• The default is 3.
7) Press next to display the Intercept screen (now go to step 6 in “Setting the Interceptor:” below)
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming for the Translation Table via the DET (continued on next page)