Programming instructions

- 167 -
DX-120 Programming Manual PROGRAMMING FOR THE OPTIONAL T1 AND ISDN (T1/PRI) CARDS
Programming for an ISDN (T1/PRI) Card (continued)
PROGRAMMING FOR A ISDN (T1/PRI) CARD VIA THE DET
See Field Descriptions on pages 165 and166 for more information about the settings via the DET.
NOTE
• chg, bksp, save, one, always, del, and ack are interactive LCD button operations.
Use the three buttons below the LCD display to activate the associated operation.
• You can press Hold at any time to return to the previous level or press the volume
buttons to return to the main DB selection screen.
1) Enter Database Administration (see page 26) using the feature code Feature # * to display the password
prompt.
2) Enter the DB Admin password (see page 27).
3) Press show to display the DB Item Select screen.
4) Enter 07-04 (see information in the following sections for making ISDN/T1/PRI settings - see table on
page
165 for details about each of these settings.).
5) Press save to enter ISDN (T1/PRI) programming.
6) Press next to go on to other ISDN (T1/PRI) programming screens.
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting CLIP (Calling Line Identification Presentation):
From the DB Item Select screen (see steps 1 through 3 on page 167):
4) Enter 07-04-01.
5) Press save to display the CLIP screen.
6) Press chg to change the setting.
• If you want to leave the current setting as is, skip to the next step.
7) Press next to display the COLP screen (now go to step 6 in “Setting COLP” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming for an ISDN (T1/PRI) Card via the DET (continued on next page)