Programming instructions

- 161 -
DX-120 Programming Manual PROGRAMMING FOR THE OPTIONAL T1 AND ISDN (T1/PRI) CARDS
Programming for a T1 Card via the DET (continued)
Setting the LPBK (Loopback) Option:
From the DB Item Select screen (see steps 1 through 3 on page 159):
4) Enter 07-03-04.
5) Press save to display the Loopback screen.
6) Press chg until the setting you want appears on the display.
• The default is NONE.
7) Press next to go to the first Wink Setting programming screen.
8) Press show to display TX Duration screen (now go to step 6 in “Make the appropriate Wink Settings:”
below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Make the appropriate Wink Settings:
From the DB Item Select screen (see steps 1 through 3 on page 159):
4) Enter 07-03-05.
5) Press save to display the TX Duration screen.
6) Press chg to select another setting (from 50 to 500 in increments of 50).
• The default is 300.
7) Press next to display RX Up Bond screen.
8) Press chg to select another setting (from 50 to 500 in increments of 50).
• The default is 400.
9) Press next to display RX Low Bond screen.
10) Press chg to select another setting (from 50 to 500 in increments of 50).
• The default is 50.
11) Press next to go to the first Caller ID programming screen.
12) Press show to display Start Digit (now go to step 6 in “Make the appropriate Caller ID Settings:” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming for a T1 Card via the DET (continued on next page)