Programming instructions

BASIC CO LINE PROGRAMMING TASKS DX-120 Programming Manual
- 142 -
Setting CO Line Time Switching via PC-DBA (continued)
2) Enter the information in the fields as described below:
3) Make the time settings for Alternate and Evening modes for the remainder of the week.
• If you do not want to use time switching for a particular day, set the beginning and ending times to
00:00.
NOTE
• Once you have set up the time switching you want to use for tenant group 1 and
are using multiple tenant grouping, use the steps above to set up time switching for
tenant groups 2 and 3, as needed.
• The DX-120 provides a shortcut if you are using multiple tenant groups, and want
to use the same time switching settings.
If this is the case, program your settings
for tenant group 1, then click
the Follow Tenant1 boxes at the top of the screen
until a check mark appears for tenant group 2 and/or 3.
If you do this, the system programs time switching for these groups to the identical
settings you entered for tenant group 1.
Thus there is no need to re-enter the
settings for the remaining tenant groups.
When you are finished:
4) Click the Update button to store the settings into the database on the local disk.
5) Click the Close button to exit the current screen and return to the PC-DBA main screen.
When you have finished all programming changes:
6) Perform a SEND to copy the database changes to the DX-120 switch system memory.
Setting CO Line Time Switching (continued on next page)
IN THIS FIELD ENTER...
Alt (for Monday)
The time you want the time switching to begin for tenant group
• The default is 12:00 PM.
To (for Monday)
The time you want the time switching to end for tenant group 1.
• The default is 01:00 PM (13:00).
Eve (for Monday)
The time you want the night, or evening, time switching to start for ten-
ant group 1.
• The default is 05:00 PM (17:00).
Eve To (for Monday)
The time you want the night, or evening, time switching to end for ten-
ant group 1.
• The default is 08:00 AM.