Programming instructions

DXP Plus Programming Instructions
/M/66-123
6.9.15
Automatic Station Relocation
Description:
The system will automatically recognize a particular station should someone relocate it to a
different station port. After being installed at a new port location, a relocated station will
provide the same class of service parameters and station features that it provided at its original
port location. Also, the relocated station will respond to the same personal intercom number that
it responded to at its original port location. A relocated station prompts the user to take action to
either accept its original programming or accept the programming at the new port. If the user
takes no action, the station assumes the parameters and personal intercom number that is
determined by the Section 6.9.16 programming procedure.
Consider these following points when you enable station relocation:
ti If someone does a station relocation, you must save the database programming to make
the relocation permanent (Section 1.6).
/ This relocation feature only applies to digital telephones.
4 Users must ensure that the vacated port remains unused until they complete a relocation
If someone connects a telephone to the vacated port before users complete a
relocation, the relocated telephone will not retain its original programming.
d When the user accept the original programming for the new port, the vacated port assumes
the programming currently assigned to the new port (that is, a parameter exchange takes
place between the vacated port and the new port).
4 If a DSS/ElLF console was assigned to the telephone at its original location, the console
assignment follows the telephone to the new location even though the console is no longer
located physically near the telephone. If you relocate the console, you must connect it to the
desired staion port and use the Section 7.4 and Section 7.2.26 procedures to program it
for use at the new port.
(/ The relocation feature also applies to relocated digital telephone boards, however, the
installer must ensure that the vacated port remains unused until the relocation is complete.
All stations connected to the relocated circuit board show the relocation prompt.
Programming:
1. Press CONTROL T for main menu.
2, From main menu, select systems and press ENTER.
3. From system menu, select system parameters and press ENTER.
4. From system parameters menu, type item number for feature and press ENTER.
5. Press SPACE bar for feature setting and press ENTER to accept setting.
6. When finished, press ESCAPE twice.
7. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
Operation: For LCD speakerphone with interactive buttons,
- relocate telephone and note Keep Yes /No display,
- press YES to keep original programming or press NO to default the station parameters.
For LCD speakerphone without interactive buttons,
- relocate telephone and note Keep display and flashing HOLD light,
- press HOLD to keep original programming or press # to default station parameters.
For Non-LCD telephones,
- relocate telephone and note flashing HOLD light,
- press HOLD to keep original programming or press #to default station parameters.
For all digital telephone types,
- relocate telephone and take no action for 10 seconds,
- relocated telephone assumes parameters determined by Section 6.9.16 programming.
Remember, station relocation only works with digital telphones.
Sys tern Features Programming 6- 31